![]() ![]() However, if you are running a PSC Hydraulic Assist, a relocated stabilizer, or no stabilizer at all, then you definitely do not need it, so no sense in making you purchase it! If you are running a steering stabilizer that mounts in the stock location, then yes, you will need to ensure to add this. Optional Tie Rod Stabilizer Clamp & Hardware - Fabricated clamp to retain factory or aftermarket stabilizer with 1/2" mounting bolt.ĭo you need to add this optional clamp kit? That really depends on your setup. The Synergy kit features tie rod ends that have the exact same taper as the factory. Other manufacturers have built upgraded steering kits, but they all required the factory knuckles to either be replaced or drilled out. One of the most important facets of this kit is that it is COMPLETELY drop in. Further, the materials in the manufacturing process will not bend, break, and will undoubtedly last the lifetime of the truck. Synergy Manufacturing set out to change all of this and create the strongest drop in steering system available for Rams, and so they did! In order to eliminate the rotational issues of the tie rods, Synergy manufactured "wobble stoppers" that are literally a reinforcing cup that will not allow the tie rod to pivot on the main connecting bar. And finally, the factory steering is built out of substandard materials when used for anything besides cruising down the highway. This not only causes excessive wear, but can also cause them to unexpectedly shear off, resulting in a complete loss of steering control. One of the main drawbacks of the factory T-style steering is that the tie rod ends are allowed to rotate a significant amount at the knuckles. ![]() The T-style steering eliminated the pivot point between the wheels, but still had its own short comings. Later, in mid-model year 2008, Dodge released an updated T-Style steering that would eventually supersede all of the previous Y-Style systems. Essentially, it featured a pivot point between the two wheels where the drag link and main tie rod were attached. There are numerous causes of this, one of which is due to the original "Y-Style" steering that came factory on the 2003-2008 model year Ram HD's. In short, Death Wobble occurs when the wheels are allowed to move somewhat independently of each other, causing a violent shaking of the front end. 2016 - 2022 Canyon/Colorado 2.8L Duramaxĭeath Wobble.nearly everyone has heard of it, especially if you have owned a Dodge Ram. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |